BPM 3000/4000 Series Autohandler

  • Corrected a problem when the site is disabled but the stepper motor will not raise when the user clicks the “close sockets”
  • Corrected an issue where the machine would not initialize with LPLA Cyberoptics camera
  • Improvements to Inc120 Cyberoptics usage.
  • Corrected an issue where Keyence laser users were having unsupported specifier errors during laser test when no specifiers were used.

Device Programming

  • Corrected an error message and clarified instructions for performing AC measurement during calibration verification.
  • Enabled customers to be able to certify 9th Gen site calibration through COC.
  • Increased the reliability of analog slew rate test.
  • Corrected a device continuity error that appeared for some algorithms on 9th Gen.
  • Increased the reliability of analog slew rate test.
  • Corrected a device continuity error that appeared for some algorithms on 9th Gen.
  • Corrected a problem where some 9th Gen sockets were not being fully actuated when 4 sockets were installed on a given site.
  • Corrected a problem where the Mechanical Benchmark device selection would issue a site memory integrity error.
  • “Unsupported” error message is removed for Freescale Semiconductor MC9S08QG8CDTE or other devices when auto continuity is set as the reverse test on 9th gen site.
Share This