Waferscale Integration ZPSD312R PLCC(44) Device
Adapters for Automated Programmers
| 6th Gen | 7th Gen |
| FASM44P, FASM44PF, FASM44PW | FASM44P, FASM44PF, FASM44PW |
Adapters for Manual Programmers
| 6th Gen | 7th Gen |
| FSM44P, FSM44PA, FSM44PF, FSM44PW, FSM84UP, FASM44P, FASM44PF, FASM44PW, FSM84AH (obs.), FSM84UPB (obs.), FSM84AHA (obs.) | FSM44P, FSM44PA, FSM44PF, FSM44PW, FSM84UP, FASM44P, FASM44PF, FASM44PW, FSM84AH (obs.), FSM84UPB (obs.), FSM84AHA (obs.) |
Adapters for Engineering Programmers
| 6th Gen | 7th Gen |
| FSM44P, FSM44PA, FSM44PF, FSM44PW, FSM84UP, FASM44P, FASM44PF, FASM44PW, FSM84AH (obs.), FSM84UPB (obs.), FSM84AHA (obs.) | FSM44P, FSM44PA, FSM44PF, FSM44PW, FSM84UP, FASM44P, FASM44PF, FASM44PW, FSM84AH (obs.), FSM84UPB (obs.), FSM84AHA (obs.) |
Last Updated: 05/18/2023
If the device is not yet supported by your BPM programmer (Generation), request Device Support
Note
IMPORTANT: Use special module ASM44PW for best yield.The PSD data file (.obj) generated by WSI software may contain data atlocations that are not programmable. This may result in an incorrect checksum.To get the correct checksum perform a SUM’ operation after programming thedevice. Some bits of PAD ACR and PORT Configuration are not defined.In order to make Compare pass these bits must be set to 0 in your data file.Verification after programming is a redundant operation and will failif the part is secured (the SECA bit of the ACR bytes is set to 0).To disable it set ‘Verify after programming’ to ‘None’.If Verify is enabled the device is only verified at nominal voltage. ‘
BPM does not sell programmable devices, nor do we program devices directly. BPM makes programmers and accessories to make programming in-house fast, easy, and profitable.
Additional information
| 8-bit Bytes | 66058 |
|---|---|
| Manufacturer | Waferscale Integration |
| Packages | PLCC(44) PGA(44) |
| Part Number | ZPSD312R |
| Set programming | Yes |
| Vcc(program) | 6.2 |
| Package |