Texas Instruments UCD90320ZWS FU (Rev. 3.0.0.3029) Custom 01 BGA(169) Device
Adapters for Automated Programmers
| 8th Gen | 9th Gen |
| FVE4ASM169BGC, FVE4ASM169BGC | FVE4ASM169BGC |
Adapters for Manual Programmers
| 8th Gen | 9th Gen |
| FVE4ASM169BGC, FVE4ASM169BGC | FVE4ASM169BGC |
Adapters for Engineering Programmers
Last Updated: 05/18/2023
If the device is not yet supported by your BPM programmer (Generation), request Device Support
Note
IMPORTANT:
This is a custom device selection to upgrade the firmware revision to 3.0.0.3029 and program the Data Flash.
This selection used the data file ‘XG801_UCD90320_v0C_Data Flash.hex’ only.
| Memory type |
Attributes(*) | DUT Physical Byte Address(hex) | BPWin Buffer Byte Address |
| Firmware | W/E Cannot read | 0-17FFF | 0-17FFF |
| Data Flash | R/W | 38800-3A207 | 38800-3A207 |
* R:Read only W:One time programmable (OTP) R/W:readable and one time programmable (OTP) W/E:Rewritable if not locked.
Data Buffer addresses [38800h-38807h] must contain a valid checksum.
If only the firmware has to be programmed set the low address to 0h and high address to 1801Fh. These address locations can only be programmed. Read and Compare does not work for these address locations.
If only the data file has to be programmed set the low address to 38800h and high address to 3A207h.
Serialization is currently not supported.
BPM does not sell programmable devices, nor do we program devices directly. BPM makes programmers and accessories to make programming in-house fast, easy, and profitable.
Additional information
| 8-bit Bytes | 238088 |
|---|---|
| Manufacturer | Texas Instruments |
| Packages | BGA(169) |
| Part Number | UCD90320ZWSFU |
| Vcc(program) | 3.3 |