Microchip Technology PIC16F18324-E/JQ QFN(16) Device

IMPORTANT:

Device Type:	Microcontroller
Device Size:	32 KByte Program Flash Memory with 256 Byte EEPROM
Algorithm Programming Method:	In-Circuit Serial Programming (ICSP) interface
Serialization Supported:	Yes

Memory Organization:

Memory Type	*Attributes^()**	Included in default Range (Y/N)	DUT Physical Byte Address(hex)(if this area is selected/Activated)	BPWin Buffer Byte Address(hex)
Program Flash Memory	R/W/E	Yes	0000-0FFF	0000-0FFF
EEPROM	R/W/E	Yes	F000-F0FF	F000-F0FF

Default Algorithm Range	—	—	0000_0000h – 0001_E1FFh	0000_0000h – 0001_E1FFh

* R:Read only W: One time programmable (OTP) R/W: readable and one time programmable (OTP) R/W/E: readable and rewritable if not locked. Any configurations listed under ‘Device-Specific’ in the menu item Device-> Settings will be written to the DUT during ‘Program’ operation regardless of memory range selection. Special Device Considerations:

1.	Data pattern requires a 14-bit format for Program Flash memory and 8-bit format for EEPROM
2.	Erasing the device will erase Program Memory and Data Memory along with the Configuration and ID bitsbut not Calibration words! The Calibration words are skipped during all device operations.
3.	The ID locations are addressed in the Data Pattern at [10000h-10007h].It is recommended by manufacturer that the user use only the seven Least Significant Bits of eachID locations and the remaining bits are masked to 1s during programming.
4.	Configuration words are located at Data Pattern addresses [1000Eh(LSB)-1000Fh(MSB)][10010h(LSB)-10011(MSB)] [10012h(LSB)-10013h(MSB)] and[10014h(LSB)-10015(MSB)].IDs and Configuration may be set under Device > Configure or from the above mentioned addresses in Data Pattern.